Filter
Top Products
RULESFORSAFEOPERATION(Continued)
• AnextortioncordshouMnotbeused unless
absolutely necessary. Use of improper
extenalon cord could resuh in a risk of fire and
electric shock, if extension cord must be used,
mske s.ure:
a. Tnst plrm on plug of extension cord are the
same number, size and shape Its those of
plug on charger.
b. That extension cord is properly wired and in
good electrical ccad_on; and
c. That wire size is large enough for AC
ampere rating ofcharger as specified
below:
Cord Length (Feet) 25' 50' 100'
Cord Size (AWG) 16 16 16
Note: AWG = American Wire Gage
DO NOT OPERATE CHARGER WITH A
DAMAGEO CORD OR PLUG, If damaged,
have replaced immediately by a qualified
sePAceman.
• Do not operate charger ff it has i'l)c_Jveda
sharp blow. been dropped, or otherwise
damaged in any way; take It to a qualified
servtcettlan.
• Do not disassemble charger; take it to a
qualified serviceman when service or rapalr is
required. Incorrect reassembly may result In a
riskof electric shcck or fire.
• To reduce risk of electric sho_k, unplug charg(
from outlet before attempting any maiotensnc_
or cleaning. Turning off controls will not reduc_
this risk.
• Do not use charger outdcors.
• Disconnect charger from power supply when
not in use.
• SAVE THESE INSTRUCTIONS. Refer to then
frequently and use them to instruct others whq
may use this tool. Ifyou loan someone this tc,
loan them these instructions also.
Look for this symbol to point out important safety precautions. It means attention!!! Your
safety is involved.
SAVE THESE INSTRUCTIONS
IMPORTANT INFORMATION FOR RECHARGING HOT BA1TERIES
When using your drill-driver continuously, the batteries in your battery pack will become hot. You should let a h_
battery pack coof down for approximately 30 minutes before attempting to recharge.
Note: This situation only occurs when continuous use of your drill causes the batteries to beeome hot. It does
not occur under normal circumstances. Refer to "CHARGING BATTERY PACK" for normal recharging of
betteri'-_. If the chsrger does no*_chsrge your b_ttenj pack under normal circumstances, rstum both the batten
pack and charger to your nearest Sears repair center for electrical check.
,_ WARNING:
The opera, on of any power toot can resu_ in foreign objects being thrown k_toyour eyes,
which can result in severe eye damage. Before beginning power tool operation, always we
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shidids, avalledio at Sears Retail Stores.