Filter
Top Products
G8693 Mini Shaper -13-
Site Consideration
If the Mini Shaper is to be used in a permanent
location, it should be fastened securely to a firm
supporting surface such as a workbench. Holes
should be drilled through supporting surface of
the workbench as illustrated. Each foot of the Mini
Shaper should be bolted securely using
1
⁄
4'' bolts,
hex nuts and lock washers. Bolts should be of
sufficient length to accommodate foot of Mini
Shaper, washer, hex nut and thickness of sup-
porting surface. Tighten all four bolts securely. If
the Mini Shaper is to be used in a portable appli-
cation, it is recommended that it be fastened to a
mounting board. The board should be of sufficient
size to avoid tipping of the Mini Shaper while in
use. Any good grade of plywood or chipboard
with a
3
⁄4'' minimum thickness is recommended.
Mount Mini Shaper to board using hole pattern as
shown. Before each use, clamp board securely to
workbench or supporting surface.
Supporting surface where Mini Shaper is mount-
ed should be examined carefully after mounting
to insure that no movement during use can result.
If any “tipping” or “walking” is noted, secure work-
bench or supporting surface before operating.
Figure 6. Hole Pattern
Bench Load
:
Your G8693 Mini Shaper repre-
sents a small weight load in a small footprint.
Most commercial or home shop benches should
be sufficient to carry the weight of the G8693. If
you question the strength of your workbench, you
can opt to reinforce it, or consider securing the
Mini Shaper on a freestanding bench like
Grizzly’s Shop Fox
®
tool table.
Working Clearances: Working clearances can
be thought of as the distances between machines
and obstacles that allow safe operation of every
machine without limitation. Consider existing and
anticipated machine needs, size of material to be
processed through each machine, and space for
auxiliary stands and/or work tables. Also consid-
er the relative position of each machine to one
another for efficient material handling. Be sure to
allow yourself sufficient room to safely run your
machines in any foreseeable operation.
Lighting and Outlets
: Lighting should be bright
enough to eliminate shadow and prevent eye
strain. Electrical circuits should be dedicated or
large enough to handle combined motor amp
loads. Outlets should be located near each
machine so power or extension cords are not
obstructing high-traffic areas. Be sure to observe
local electrical codes for proper installation of
new lighting, outlets, or circuits.
Make your shop “child safe”. Ensure that
your workplace is inaccessible to young-
sters by closing and locking all entrances
when you are away. Never allow visitors in
your shop when assembling, adjusting or
operating equipment.