Filter
Top Products
G8693 Mini Shaper -17-
The Ring Guard (REF 19) is an important safety
feature and should always be used when shap-
ing. Before the Mini Shaper is turned on, the ring
guard should be positioned approximately
1
⁄4''
above the workpiece and locked in place.
When making adjustments or setting the cutter,
the Ring Guard can be loosened and rotated out
of the way.
Ring Guard
The keyed Washer must be directly under the
JAM NUT; otherwise, the nut may loosen and
serious injury may result. Always lock the spindle
knob after adjusting it. See Figure 13.
Keyed Washers
Figure 13.
Keyed Washer
Jam Nut
Figure 12.