Filter
Top Products
G8693 Mini Shaper -23-
Keep your Mini Shaper clean and adjusted prop-
erly for maximum performance and machine
longevity. Do not allow pitch to accumulate on the
table, fences or cutters. Clean frequently with
Gum and Pitch Remover.
The table and other non-painted surfaces on the
Model G8693 should be protected against rust
and pitting. Wiping the Shaper clean after every
use ensures that moisture from wood dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron
surfaces. The wax provides a layer of protection,
as well as reducing friction between lumber and
the table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that’s being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it’s 100% Carnauba wax.
2. Turn Mini Shaper upside down on a firm work
surface. Be careful to remove or protect the
Stub Shaft from damage.
3. Remove Belt Guard (REF 47) by loosening
the mount screw (REF 49).
4. Remove old Timing Belt (REF 46) by turning
belt and applying outward pressure.
5. Install new belt by starting it on pulleys and
maintain inward pressure until full width of belt
is on both pulleys.
6. Should the belt tension need adjustment,
loosen four hex head bolts (REF 61) on Motor
Mount (REF 54). Slide Motor Mount in or out
until sides of timing belt are straight between
pulleys. NOTE: Do not over-tension this belt,
it only needs to be straight. Excessive tension
may shorten the life of the motor bearings.
Tighten bolts and make sure the belt runs
straight and true.
7. Replace the belt guard before operating.
SECTION 5: MAINTENANCE
Replacement belts are available from Grizzly
Parts Department.
1. Turn the Mini Shaper off, remove the switch
key and unplug!
Failure to unplug your Mini Shaper could
result in accidental starting and serious injury
and that would be bad.
Belt Replacement
Figure 20.
For your safety, turn the Mini Shaper off,
remove the switch key and disconnect the
machine from power source before
attempting any repairs or maintenance on
the shaper. Failure to observe this will
result in serious personal injury.