Filter
Top Products
CHiP BAG ASSEMBLY -
LOWER FiLTRATiON HOUSING
1. Insert lower Chip Bag by tilting the Metal Reinforced
Bandat an angle and positionitthrough the hole inthe
lower Filtration Housing.
2. Tuck one side of the Band under the Sawdust
Chute Extension.
3. Allow the opposite side to rest on the ridge of the
opening.
4. Tug on the Chip Bag to insure proper seating,
F_LTRATION HOUSING
SAWDUST CHUTE
EXTENSION
UPPER FILTER/DUST BAG ASSEMBLY
1. Disconnect the Adjustable Band Clampand insertthe
end through the loops provided at the opening of the
Filter/Dust Bag.
2, Invert the Filter/Dust Bag and slip the open end of the
Bag over the 1" Relief on the top opening of the
Filtration Housing.
3, Secure the Bag byadjusting the rectangular barto the
fourth set of hooks.
4. Pull the lever tight until it seats itself.
_ CAUTION: Make sure the opening of the bag is
tight against the relief so dust will not escape.
FILTER/
DUST BAG
HOLDER
HANDLE---_
RELIEF /
FILTER/
DUST BAG
ADJUSTABLE
BAND CLAMP
tl