Filter
Top Products
........ iiiiii ii ,i ,i,
introduction
The Craftsman Dust Collection System is specifically
designed to capture sawdust and wood chips at the
source. The fine dust is filtered by the upper bag while
heavy particles settle in the lower bag for easy removal.
Do not use as a vacuum.
_ CAUTION: The blower housing containsa high
speed fan bgade that can amputate fingers, grab
loose clothing and neckties, or prope_ dust at high
velocities. DO NOT OPERATE WITHOUT ALL PARTS
IN PLACE.
Do not attempt to clean, remove dust bags or service
unit while in operation. Disconnect from power
source.
This Dust Collection System is intendedfor either corn*
mercial or household use.
IMPORTANT NOTE
Please Read Carefully
Static Shocks Are Common - in dry areas or when the
relative humidity of the air is low. To reduce the fie-
quency of slatic shocks in your home, the best remedy
is to add moisture to the air with a console or installed
humidifier.
The safety information in this manual is highlighted by
the following safety alert symbol.
]'he following signal words are used to indicate the lever
of risk.
_ DANGER: Means that if the safety information
is not followed, someone will be seriously injured or
killed.
_ WARNING: Means that ifthe safety information
is not followed, someone could be seriously injured or
killed.
_, CAUTION: Means that if the safety information
is not followed, someone may be injured.
TABLE OF CONTENTS
ITEM PAGE
WARRANTY INFORMATION .................................... 2
IMPORTANT SAFETY INSTRUCTIONS ................... 2
GENERAL SAFETY INSTRUCTIONS FOR
POWER TOOLS .................................................... 4
INTRODUCTION ........................................................ 5
Unpacking and Checking Carton Contents ............ 6
ASSEMBLY ................................................................ 7
Mounting Front Pivoting Casters ........................... 7
Mounting
Mounting
Mounting
Mounting
Mounting
Mounting
Mounting
Mounting
Chip Bag
Rear Fixed Casters ................................ 7
Inlet Guard ............................................ 7
Support Legs .......................................... 8
Leg Bracket ............................................ 8
inlet Bracket ........................................... 9
Base Plate .............................................. 9
Filter/Dust Bag Holder .......................... i0
Handle to Filtration Housing ................. 10
Assembly ............................................. 11
ITEM PAGE
Filter/Dust Bag Assembly .................................... 11
OPERATION ............................................................ 12
Attaching Accessories to inlet Guard .................. 12
Connecting Dust Collection System to
Power Source ................................................... 12
OnlOff Switch ...................................................... 13
Moving Dust Collection System ........................... 13
Power Supply ...................................................... t4
Grounding Instructions ........................................ 14
Extension Cords .................................................. 14
MAINTENANCE ....................................................... t 5
Chip Collecting Bag Removal .............................. t5
Filter/Dust Bag Removal ...................................... 15
Motor ................................................................... 16
TROUBLESHOOTING ............................................. 16
REPAIR PARTS ...................................................... 18
5