Filter
Top Products
Back to Contents Page
Cooling Fan
Dell™Latitude™X300ServiceManual
Removing the Cooling Fan
1. Remove the battery.
2. Remove the keyboard.
3. Remove the palm rest.
4. Remove the four M2 x 3-mm screws that secure the cooling fan to the system board.
5. Remove the tape that secures the cooling fan cable to the fan.
6. Disconnect the cooling fan cable from the system board connector.
7. Lift the cooling fan up and out of the bottom case.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
NOTICE: Disconnect the computer and any attached devices from electrical outlets.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Before You Begin" before performing the following procedure.
1
M2 x 3-mm screws (4)
2013T
2
cooling fan
D2589
3
cooling fan cable
4
cooling fan connector
5
system board connector
NOTICE: Do not pull on the cooling fan cable. Pull from the cooling fan connector to disconnect the cable.