Filter
Top Products
Display Assembly
Removing the Display Assembly
1. Remove the battery.
2. Remove the keyboard.
3. Turn the computer over, and remove the two M3 x 5-mm screws from the bottom of the computer.
4. Turn the computer over and open the display 180 degrees.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
NOTICE: Disconnect the computer and any attached devices from electrical outlets.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Before You Begin" before performing the following procedure.
1
M3 x 5-mm screws (2)
7T775