Filter
Top Products
Back to Contents Page
Hard Drive
Dell™Latitude™X300ServiceManual
Removing the Hard Drive
Replacing the Hard Drive
Removing the Hard Drive
1. Remove the battery.
2. Remove the keyboard.
3. Remove the palm rest.
4. Loosen the four M2 x 5.5-mm screws that secure the hard drive to the bottom case.
Rubber grommets secure each screw to the hard drive so that you do not need to completely remove the screws.
5. Disconnect the hard drive connector from the system board.
6. Lift the hard drive up and out of the bottom case.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
NOTICE: Disconnect the computer and any attached devices from electrical outlets.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Before You Begin" before performing the following procedure.
1
hard drive connector
2
hard drive
see Mini RSL
3
M2 x 5.5-mm screws (4)
6K709