Filter
Top Products
Back to Contents Page
Palm Rest
Dell™Latitude™X300ServiceManual
Removing the Palm Rest
Replacing the Palm Rest
Removing the Palm Rest
1. Remove the battery.
2. Remove the keyboard.
3. Turn the computer over, and remove the three M2 x 4-mm screws from the bottom of the computer.
4. Turn the computer over, and open the display.
5. Remove the six M2 x 4-mm screws on the palm rest.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
NOTICE: Disconnect the computer and any attached devices from electrical outlets.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Before You Begin" before performing the following procedure.
1
M2 x 4-mm screws (3)
98MKC