Filter
Top Products
12. Disconnect the left and right speakers from their system board connectors.
13. Remove the reserve battery.
14. Disconnect the Bluetooth cablefromthesystemboard,ifaBluetooth™deviceispresent.
15. Lift the ZIF connector, and remove the status light (LED) cable from its ZIF connector on the system board.
16. Lift the system board up, from the right side, and out of the bottom case.
Replacing the System Board
1. Place the system board in the bottom case.
2. Reconnect all the cables to the system board ZIF connectors.
3. Reinstall the three M2 x 4-mm screws that secure the system board to the bottom case.
Back to Contents Page
1
system board
see Mini RSL
2
M2 x 4-mm screws (3)
98MKC
3
status light (LED) cable
4
ZIF connector
NOTE: The Reserve battery should be attached on the memory chip surface during transportation to the repair center.
NOTE: Route cables so that they will not be crimped or pinched when the complete assembly is put back together.
1
wireless antenna
NOTE: After replacing the system board, enter the computer Service Tag into the BIOS of the replacement system board.