Filter
Top Products
Back to Contents Page
Memory, Modem, and Mini PCI Card Modules
Dell™Latitude™X300ServiceManual
Adding Memory
Replacing a Modem
Adding a Mini PCI Card
Adding Memory
You can increase your computer memory by installing a memory module on the system board. See the "Specifications" section in your System Information Guide
for information on the memory supported by your computer. Be sure to add only a memory module that is intended for your computer.
1. Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2. Save and close any open files, exit any open programs, and shut down the computer.
3. If the computer is connected to the media base (docked), undock it. See the documentation that came with your media base for instructions.
4. Disconnect the computer from the electrical outlet.
5. Wait 10 to 20 seconds, and then disconnect any attached devices.
6. Remove any installed PC Cards and battery.
7. Turn the computer over, unscrew both captive screw(s) from the memory module/Mini PCI/modem cover, and remove the cover.
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts. Ground yourself by touching a metal connector on the
back of the computer. Continue to ground yourself periodically during this procedure.
1
captive screw (2)
2
memory module cover
H0164
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.