Filter
Top Products
20
DRILLING METAL
Use clamps to hold the workpiece. DO NOT try to hold the workpiece with your hand. The drill bit may seize the work at
any time and spin, causing damage to the machine and/or injury to you. The drill bit will break if the workpiece strikes
the column.
Clamp the workpiece firmly. Tilting, twisting, or shifting will result in a rough hole and drill bit breakage. For flat work,
lay the workpiece on a wooden base and clamp it firmly against the table. If the workpiece is of irregular shape and
cannot lie flat on the table, make sure that you clamp it securely.
REMOVING SPINDLE ADAPTER
1. Align the slot in the quill (A) Fig. 34 with the slot in the spindle (B).
2. Insert the drift key (C) Fig. 35 through the slot in the quill and the slot in the spindle.
3. Tap the drift key (C) Fig. 35 with a hammer until the the spindle adapter and chuck fall from the quill.
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call
the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
Disconnect the machine from the power source!
The spindle adapter and chuck can be removed for the purpose of using shanks with a #2 morse taper.
B
A
C
Fig. 34
Fig. 35