Filter
Top Products
12
OPERATION
STARTING AND STOPPING THE SAW
Make sure that the switch is in the
“OFF" position before plugging cord
into outlet. Do not touch the plug’s metal prongs when
unplugging or plugging in the cord
Do not attempt to operate this tool
without first connecting it to an
adequate dust collection system
NOTE: The DELTA
®
14" Steel Frame Band Saw uses
a Safety Key (A), shown in Figure 12. The Safety Key
must be in place in order to operate the machineBefore
attempting to turn on the band saw, ensure the Safety
Key is installed.
The power switch is located on the left side of the
machine. To turn the machine "ON", ensure the yellow
safety key is installed and lift the red power switch (B)
To turn the machine "OFF", press up on the red power
switch.
In the event of a power outage (such as
a breaker or fuse trip), always move the
switch to the “OFF" position until the main power is
restored.
FIGURE12
USING THE SAFETY KEY TO LOCK THE SWITCH
IN THE "OFF" POSITION
When the tool is not in use, the switch should be
locked in the “OFF" position. This can be done by
grasping the Safety Key (A), shown in Figure 12 above,
and pulling it out of the switch. With the Safety Key
removed the switch will not operate. Should the Safety
Key be removed while the machine is running, the
switch can be turned “OFF" once, but cannot be
restarted without inserting the Safety Key.
IMPORTANT: Store the Safety Key away from the tool
to prevent unauthorized use
SELECTING PROPER CUTTING SPEED
Your DELTA
®
14" Steel Frame Band Saw has two
cutting speeds: low (1620 ft./min )and high (3340 ft./
min). The cutting speed is determined based on which
of the two pulley wheels, shown in Figure 13 is in use.
The larger diameter pulley wheel (A) is used for the
lower cutting speed while the smaller diameter wheel
(B) is used for the higher speed.
• To change the cutting speed, open the lower wheel
guard (C).
• Refer to the diagram and instructions (D) posted on
the inside of the wheel guard.
• Reduce tension on the pulley belt using the belt
tensioning knob (E).
• Place belt on the proper wheels and hand turn to
ensure it tracks in the center of both wheels.
• Re-tension pulley belt using the belt tensioning knob.
• Close the lower wheel guard.
FIGURE 13