Filter
Top Products
8
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil
from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual
are representative only and may not depict the actual labeling or accessories included. These are intended to
illustrate technique only.
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the sander and/or property!
Your DELTA
®
14" Steel Frame Band Saw comes packed in a single container. Use a safety strap to avoid tip-over
when lifting machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always
check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean
work surface and check that all parts are present and in good condition:
PRODUCT SPECIFICATIONS
UNPACKING
DESCRIPTION (QUANTITY)
• Stand Legs (4)
• Bottom Stand Braces (4)
• Stand Top (1)
• Stand Hardware Pack (1)
• Cast Iron Work Table (1)
• Top Trunnion (1)
• 93 ½" Band Saw Blade (1)
• Blade Tensioning Handle (1)
• Throat Plate (1)
• Hardware Pack (1)
Motor 1 HP, 120V
Cutting Capacity - Height 6"
Cutting Capacity - Width 13-5/8"
Minimum Blade Width 1/8"
Maximum Blade Width 3/4"
Blade Length 93-1/2"
Blade Speed - Low 1620 ft./min (490m/min.)
Blade Speed - High 3340 ft./min (990m/min)
Table Size 15-3/4" X 18-7/8"
Table T-Slot Size (DxW) 3/8" X 3/4"
Table Height From Floor 40-3/4"
Table Tilt 3° left - 45° right
Dust Port Diameter 4"
Overall Dimensions (HxWxD) 27" X 19" X 65-1/2"
Net Weight 180 Lbs.
Shipping Weight 165 Lbs.
CONTENTS OF STAND
HARDWARE PACK
• M6 X 16 Carriage Bolts (24)
• M6 FLAT Washers (24)
• M6 HEX Nuts (24)
• Rubber Feet (4)
CONTENTS OF TOOL
HARDWARE PACK
• M8 X 20 Hex Bolts (8)
• M6 Lock Washers (4)
• M6 Flat Washers (4)
• (size) Trunnion Feed Bolt (1)
• 8MM Flat Washer (1)
• Table Tilt Locking Wing Nut (1)
• M8 Flat Washers (4)
• M8 Lock Washers (4)
• M8 Hex Nuts (4)