Delta 36-240 Saw User Manual


 
13
Fig. 34
Fig. 35
Fig. 36
Fig. 37
ADJUSTING SLIDING FIT
BETWEEN MOVABLE
TABLE AND BASE
When it becomes necessary to adjust the sliding fit
between the movable table and the base proceed as
follows: Turn nut (A) Fig. 34, clockwise to increase or
counterclockwise to decrease the sliding fit. This
adjustment should not be too tight that it restricts the
rotating movement of the table or too loose that it
affects the accuracy of the saw.
ADJUSTING FENCE
90 DEGREES TO BLADE
IMPORTANT: BEFORE MAKING THIS ADJUSTMENT,
MAKE CERTAIN THE BLADE IS SET AT 90 DEGREES
TO THE TABLE. SEE SECTION “ADJUSTING 90 AND
45 DEGREE BEVEL POSITIVE STOPS.”
1. DISCONNECT THE TOOL FROM THE POWER
SOURCE.
2. Rotate the table so that the blade is 90 degrees to
the fence and the spring-loaded positive stop for the 0
degree mark on the scale is engaged.
3. Using a square (A) Fig. 35, place one end of the
square against the fence (B) and the other end against
the blade as shown. Check to see if the fence is 90
degrees to the blade.
4. If an adjustment is necessary, the fence (B) can be
adjusted by loosening the two screws, one of which is
shown at (C) Fig. 35, that attach the fence to the base,
using wrench (D) supplied. Adjust the fence (B) as
required and tighten two screws (C).
5. After you are sure the fence is 90 degrees to the
blade, adjust the two cursors, one of which is shown at
(E) Fig. 36, so the pointer is aligned with the 0 degree
mark on the scale by loosening screw (F), adjusting
cursor (E) and tightening screw (F).
TABLE HAZARD AREA
WARNING: THE AREA INSIDE THE RED LINE (A)
FIG. 37, ON THE TABLE IS DESIGNATED AS A
HAZARD ZONE. NEVER PLACE YOUR HANDS
INSIDE THIS AREA WHILE THE TOOL IS BEING
OPERATED.
A
A
B
D
C
E
F
A
A
A