Filter
Top Products
24
USING THE SAW ON SAW HORSES
Figs. 69 and 70, illustrate the saw placed for use on saw horses. Notches in the front and rear of the
mounting feet are designed to fit conveniently on saw horses. FOR MODEL 36-250 ONLY: Please note
the table extensions and auxiliary fences (A) Fig. 70, can be used when operating the stand model on
saw horses.
USING SAW WITH 2 X 4 EXTENSIONS
1. Fig. 71 illustrates the saw being used with 2 x 4 extensions. Note that notches in the front and rear
of the mounting feet (K) are designed to fit and fastened to the top of the two 2 x 4’s (P). The length of
the two 2 x 4’s (P) can vary depending on your preference. The distance from the top of the 2 x 4’s (P)
to the saw table is 3-1/2″. This enables you to nail or fasten standard 2 x 4’s (R) to the 2 x 4’s (P), as
shown. The top of the 2 x 4’s (R) will then be in alignment with the saw table, providing support for long
work pieces. If desired, fence extensions (S) made of 2 x 2’s can be aligned with fence (T) and bolted
to 2 x 4’s (R).
Fig. 71
Fig. 69 Fig. 70
A
A
S
R
S
R
P
P
S
R
R