Filter
Top Products
25
Fig. 72
REPLACING SAW
ON STAND
(FOR MODEL 36-250 ONLY)
When assembling the stand to the saw, reverse the
instructions listed in the section “REMOVING SAW
FROM STAND” and keep in mind that the distance
between the center of screw (A) Fig. 72, and bent hinge
screw (B) MUST BE 8
″″
and the distance between the
center of screw (C) and straight hinge screw (D) MUST
BE 8-1/2
″″
.
OPERATION
CORRECT OPERATING PROCEDURE FOR SLIDE CUTTING
WARNING: SLIDE CUTTING BY PULLING THE SAW TOWARDS THE OPERATOR CAN BE
DANGEROUS, CAUSING THE SAW TO KICK UPWARDS AND TOWARDS THE OPERATOR. ALWAYS
PUSH THE SAW FORWARD, AWAY FROM THE OPERATOR, AND TOWARDS THE FENCE WHEN SLIDE
CUTTING.The following steps illustrate the proper operating procedure to follow when slide cutting with your
compound slide saw. NOTE: Operational illustrations are shown using the slide saw on a work bench using
2 x 4 extensions.
Fig. 73
Fig. 74
1. Place the workpiece (A) on the table and against the
fence, as shown in Fig. 73. Grasp the cuttinghead
handle (B) but do not turn the saw on at this time.
2. Pull the cuttinghead (C) Fig. 74, toward you, with the
cuttinghead in the up position. After the cuttinghead is
pulled toward you, compress switch trigger to turn the
saw on, as shown.
A
B
D
C
A
B
C