Filter
Top Products
7
Fig. 7
Fig. 8
Fig. 9
Fig. 11Fig. 10
3. Pivot the machine so feet (D) Fig. 7, of the left leg are
on the floor. NOTE: Make certain the leg hinges (C) Fig.
7, are locked in place before raising the machine to an
upright position.
4. Raise the right side of the machine and unfold right
leg (A) Fig. 8. Lock right leg (A) in position by pushing
hinges (E) inward.
5. Loosen four lock knobs on leg assemblies, two of
which are shown at (F) Fig. 8.
6. With foot on lower brace (G) Fig. 9, lift up table
extension (H) so upper leg (J) extends out from lower leg
(K) and protrusions (L) Fig. 10, snap in and engage with
round holes in upper legs (J). This locks the upper and
lower legs (J) and (K) in position. Tighten two locking
knobs (F) Fig. 10.
7. Pull right side upper leg (L) Fig. 11, from lower leg (K)
in the same manner. Tighten the remaining two locking
knobs (F). CAUTION: Make certain both legs are fully
extended and locked in position before operating the
saw.
B
C
D
F
E
F
A
G
K
J
H
J
J
F
K
K
F
L
L
K
F