Filter
Top Products
10
Fig. 4
Fig. 5
Fig. 6
ASSEMBLING EXTENSION WING
NOTE: CHECK TO SEE WHAT TYPE OF STARTER
BOX WAS SHIPPED WITH YOUR SAW (GPE OR LVC).
A GPE STARTER HAS ROUND “ON” AND “OFF”
BUTTONS. A LVC STARTER HAS RECTANGLE “ON”
AND “OFF” BUTTONS.
NOTE FOR GPE ST
ARTER BOX: If your Unisaw was
shipped with an GPE starter box, the GPE “ON/OFF”
switch must be removed from the left side of the
Unisaw. When assembling the left extension wing, do
not install the front screw and washer at this time, it
will be installed when assembling the on/off switch.
NOTE FOR L
VC STARTER BOX: If your Unisaw was
shipped with an LVC starter box, the LVC “ON/OFF”
switch must be removed from the left side of the
Unisaw. Save the hardware that attached the LVC
“ON/OFF” switch to the Unisaw because it will be
used to re-attach the “ON/OFF” switch to the left
extension wing in the section “ASSEMBLING LVC
ON/OFF SWITCH.”
Assemble left extension wing (A) Fig. 5 to the saw table.
Align the three holes in the extension wing with the three
holes in the side of the saw table. Place a 7/16" flat
washer on a 7/16-20x1-1/4” hex head screw. Insert the
screw through the hole in the extension wing and thread
the screw into the tapped hole in the side of the table.
Repeat this process for the two remaining holes in the
extension wing and saw table. NOTE: TIGHTEN
SCREWS ENOUGH TO HOLD WING IN PLACE, BUT
LOOSE ENOUGH TO ALLOW THE WING TO BE
ADJUSTED FLUSH WITH THE TABLE.
With a straight edge (C) Fig. 6, make certain the
extension wing (A) is level with the saw table. Then,
tighten all three screws (B) Fig. 5 with an 18mm open
end wrench.
NOTE: MAKE SURE FRONT EDGE OF WING IS FLUSH
TO OR SLIGHTLY BEHIND THE FRONT EDGE OF THE
TABLE.
Place the right extension wing on the other side of the
saw in the same manner.
A
C
F
B
A
B