Filter
Top Products
Use a light oil to lubricate eccentric (A) Fig. 78, and pivot points (B) on both the headstock and the tailstock. (Tailstock
illustrated).
Use the tip of a screwdriver (A) Fig. 79 to press on the opening, and drop light oil into the handwheel cover (B) of the
tailstock.
LUBRICATION
7. While holding the control panel (A) Fig. 76 with one hand, remove the cover (B) Fig. 76. To prevent the control panel
(A) from falling, loosely re-attach the hex screw (B) Fig. 75 to the control panel.
8. Replace the belt (A) Fig. 77.
9. To assemble, reverse the procedure.
22
5. Use a Phillips screwdriver (A) Fig. 74 to remove the five cover screws (B) (three of which are shown). The other two
screws are located under the power cords.
6. With a 5/16” hex wrench (A) Fig 75, remove the hex screw (B) Fig. 75. NOTE: When re-assembling, pass the screw
completely through the pivoting control bracket and into the headstock, allowing the headstock cover to pivot.
B
A
A
B
A
B
A
B
A
A
B
Fig. 74
Fig. 75
Fig. 76
Fig. 77
Fig. 78 Fig. 79