5
ASSEMBLY
Fig. 4
Fig. 5
Fig. 6
Fig. 8Fig. 7
ASSEMBLING
CASTERS TO BASE
1. Insert threaded rod of caster (A) Fig. 4, into the hole
located on the underside of base (B) and fasten with
3/8" lockwasher (C) and 3/8-16 hex nut (D). Fig. 5,
illustrates the caster fastened to the base.
2. Assemble the remaining three casters to the
underside of the base in the same manner.
ASSEMBLING BLOWER
AND MOTOR ASSEMBLY
TO BASE
1. Turn base (A) Fig. 6, right side up. Align the
mounting holes at the base of blower and motor
assembly (B) Fig. 6, with six pre-drilled holes (C) in base
(A) and fasten with six 5/16-18x5/8" hex head screws (D)
and 5/16" lockwashers (E).
2. Fig. 7, illustrates the blower and motor assembly (B)
fastened to base (A).
3. Assemble drum support (F) Fig. 8, to the two
threaded holes in the corner of base (A), as shown in
Fig. 8, with two 5/16-18x5/8" hex head screws and
5/16" lockwashers (G). NOTE: Do not completely tighten
hardware at this time.
A
B
C
D
D
E
A
C
C
B
A
B
F
G
G
A
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.