Filter
Top Products
13
Model 550 Tube Severing Tool
92-0116 : Rev. 060810
WARNING:
REPAIRS AND REPLACEMENT
Cutter Wheel Replacement
Disconnect the Drive Unit from the Model 550 Tube Cutter prior to any repairs
or replacements.
Rotate the drive shaft manually clockwise to rotate the cutter carriage to the desired
position.
REPLACEMENT OF THE CUTTER WHEEL
Rotate the Cutter Carriage Assy until you see the Cutting Wheel and the cutter
Wheel Securing Pin access hole.
Take a small screwdriver and a pair of needle nose pliers to remove the Wheel
Securing Pin.
Insert a pair of needle nose pliers and take hold of the edge of the Cutter Wheel and
remove it from the Model 550 Tube Cutter.
Take the new Cutter Wheel and install it by reversing the removal procedure.
REPLACEMENT OF THE BEARING PLUGS
Rotate the Cutter Carriage Assy until the Bearing Plug that is to be replaced can be
seen.
Press out the worn Bearing Plug.