Filter
Top Products
English
9
Installing and Removing the
Battery Pack (Fig. 2)
NOTE: Make sure your battery pack is fully charged before you
install it.
INSTALLING THE BATTERY PACK
1. Release latch (B) to open the hatch door (A). Insert the battery
pack (C).
CAUTION: The laser will operate even if battery door is not
fully latched. To secure the battery, always ensure battery door
is closed and latched.
2. Slide the battery pack in firmly.
3. Close the hatch door and fasten latch.
REMOVING THE BATTERY PACK
1. Release latch to open the hatch door.
2. Remove the battery pack.
3. To recharge the battery pack, insert it into the charger as
described in the charger section of this manual.
Laser Control Panel
The laser is controlled by the power button (D), the speed/rotation
button (E), the scan mode button (F), and two arrows (G, H). The
arrows control the movement of the laser head left and right when
the laser is being used in the plumb mode. Four LED indicator lights
are on the control panel: power (I), X-axis leveling (J), Y-axis leveling
(K) and remote control private mode (L).
TURNING THE LASER ON (FIG. 3)
1. Insert the fully charged battery pack. Be sure that the battery
door is securely latched.
2. Gently press the power button (D) to power the laser on. The
power LED indicator light (J) will illuminate. If the laser is out of
level, the X-axis (J) and/or Y-axis (K) leveling lights will flash until
the laser is level. Press the speed/rotation button (E) to adjust
the rotation speed.
NOTE: The head will begin or resume rotation once the laser is
level.
KJ
I
H
G
F
E
DL
FIG. 3
TURNING THE LASER OFF
Gently press the power button to turn the laser off. The power LED
indicator light will no longer be illuminated.
Laser Control Panel Buttons
POWER BUTTON
To completely power the laser unit off, the power button on the
control panel of the laser unit must be pressed. The laser unit will
also automatically power off if it is left in Sleep Mode for 8 hours.
NOTE: Press the remote control power button to put the laser unit
into Sleep Mode. In Sleep Mode all laser unit functions shut off
except for a periodic blink from the power LED on the control panel
of the laser unit. Press the remote control power button again to
“wake up” the laser unit.