Filter
Top Products
English
5
DW7082
DW7084
LOCKNUTS
END
PLATE
DW7080
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Miter Saw LED Worklight System: DWS7085
Lighting used for greater visibility and cutting alignment during operation.
Easy to install.
SAW BLADES: ALWAYS USE 10" (254 mm) SAW BLADES WITH 5/8"
(15.9 mm) ARBOR HOLES. SPEED RATING MUST BE AT LEAST 5000 RPM.
Never use a smaller diameter blade. It will not be guarded properly. Use
crosscut blades only! Do not use blades designed for ripping, combination
blades or blades with hook angles in excess of 5º.
BLADE DESCRIPTIONS
APPLICATION DIAMETER TEETH
Construction Saw Blades (thin kerf with anti-stick rim)
General Purpose 10" (254 mm) 40
Fine Crosscuts 10" (254 mm) 60
NOTE: Thin kerf 60T blades without noise damping may ring
under no load conditions.
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts 10" (254 mm) 80
Non-ferrous metals 10" (254 mm) 80
NOTE: For cutting non-ferrous metals, use only saw blades
designed for this purpose.
Unpacking Your Saw
Check the contents of your miter saw carton to make sure that you have
received all parts. In addition to this instruction manual, the carton should
contain:
1. One DW717 miter saw.
2. One D
EWALT 10" (254 mm) diameter saw blade.
3. One blade wrench in wrench pocket shown in Figure 9.
4. One DW7053 Dustbag (some models).
5. One material clamp.
Specifications
CAPACITY OF CUT
51º miter right, 60º miter left
48º bevel left and right
0º miter
Max. Height 3.5" (89 mm) Result Width 11.9" (302 mm)
Max. Width 12.6" (320 mm) Result Height 3.0" (76 mm)
45º miter
Max. Height 3.5" (89 mm) Result Width 8.4" (213 mm)
Max. Width 8.9" (226 mm) Result Height 3.0" (76 mm)
45º bevel - Left
Max. Height 2.3" (58 mm) Result Width 11.9" (302 mm)
Max. Width 12.6" (320 mm) Result Height 2.0" (50 mm)
DW7187
DWS7085