Filter
Top Products
ENGLISH
7
Turn on the grinder and allow it to reach full speed
(2950/min). Hold the workpiece firmly and against
the tool rest. Hold very small pieces with pliers or
other suitable clamps. Feed the work smoothly
and evenly into the grinding wheel. Move the work
slowly and avoid jamming the work against the
wheel. As the wheel tends to slow down you should
occasionally release the pressure to let the wheel
return to full speed. Grind only on the face of the
grinding wheel and never on the side. (Some wheels
are designed for side grinding and will say so on
their instruction sheets).
Switch
The switch is located on the front of the grinder, on
the base. To turn the tool on depress the side of the
rocker switch on the top side, marked “1”. To turn
off the grinder, depress the base side of the rocker
switch, marked “O”.
Changing Accessories (fi g. 4)
WARNING: Do not use a damaged
grinding wheel.
1. Remove the guard cover (f) by loosening (not
removing) the three screws (h).
2. Remove the clamping nut (e) with a spanner.
3. Remove clamping flange (g) and grinding wheel.
4. Mounting new grinding wheel in reversed order.
5. Switch on the machine and let the wheel run
with no load for one minute to check for cracks.
MAINTENANCE
Your DEWALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional Accessories
WARNING: Since accessories, other
than those offered by DEWALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only DEWALT recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your DEWALT product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products and
packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.