Filter
Top Products
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ...................volts A ......................amperes
Hz .................hertz W .....................watts
min ...............minutes
or AC ..........alternating
or DC ...direct current current
.................Class I Construction or AC/DC ...alternating
.....................
(grounded) ........................or direct
.................Class II Construction current
(double insulated)
n
o ....................no load
…/min ..........per minute speed
BPM .............beats per minute
n ......................rated
IPM ...............impacts per minute
........................speed
RPM .............revolutions per
.....................earthing
minute terminal
sfpm .............surface feet
..................... safety alert
..................... per minute symbol
SPM .............strokes per minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D
EWALT tools are factory tested; if this tool does not
operate, check power supply.
COMPONENTS (Fig. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Spark guards D. Tool rests
B. Eye shields E. Switch (On/Off)
C. Coarse grinding F. Medium grinding
wheel (36 Grit) wheel (60 Grit)
FIG. 1
E
A
D
C
F
B
English
4