Filter
Top Products
overload current value (motor burn-up point). If continued overload
shutdowns occur, apply less force/weight on the tool until the tool
will function without the overload engaging.
COMPLETE ELECTRONIC CONTROL™
The internal electronic speed control offers consistent wheel speed
while using the tool.
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D
EWALT tools are factory tested; if this tool does not
operate, check power supply.
F
E
N
G
A
H
FIG. 1
I
C
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Spindle lock button
B. Spindle (not shown)
C. Side handle
D. 6" (150 mm) grinding wheel
(not shown)
E. Anti-lockup backing flange
F. Threaded clamp nut
G. Guard
H. Dust ejection system
(DES)
I. Slider switch
INTENDED USE
This grinder is designed for professional grinder, sander, wire brush,
polisher or cut-off application.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This grinder is a professional power tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
ATTACHING SIDE HANDLE (FIG. 2)
The side handle (C) can be fitted to either side of
C
FIG. 2
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened se cure ly. Use a wrench to firmly
tighten the side handle.
English
8