Filter
Top Products
Rotating the Gear Case (FIg. 3)
1. Remove the four corner screws attaching
FIG. 3
90˚
90˚
the gear case to motor housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position.
NOTE: If the gear case and motor housing
become separated by more than 1/8"
(3.17mm), the tool must be serviced and re-assembled by a D
EWALT
service center. Failure to have the tool serviced may cause brush,
motor and bearing failure.
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 20 in.-lbs. torque. Overtightening could cause
screws to strip.
Accessories
It is important to choose the correct guards, backing pads and flanges
to use with grinder accessories. See pages 9–10 for information on
choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Threaded accessories must have a 5/8"–11 hub. Every
unthreaded accessory must have a 7/8" arbor hole. If it does not, it
may have been designed for a circular saw and should not be used.
Use only the accessories shown on pages 9–10 of this manual.
Accessory ratings must be above listed minimum wheel speed as
shown on tool nameplate.
6" (150 mm) Grinding Wheels
Type 27 guard
backing flange
threaded clamp nut
Type 27 depressed
center wheel
Type 27 hubbed wheel
Type 27 guard
Wire Wheels
3" wire cup
brush
Type 27 guard
4" wire wheel
Type 27 guard
English
9