Filter
Top Products
• NIOSH/OSHA/MSHA respiratory protection.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ............ volts A .............amperes
Hz ..........hertz W ............watts
min ........ minutes
..........alternating current
.....direct current .......... alternating or direct
current
.......... Class I Construction
n
o ...........no load speed
(grounded)
.......... Class II Construction n .............rated speed
(double insulated)
…/min ....per minute
............earthing terminal
IPM ...........impacts per minute
............safety alert symbol
SPM .........strokes per minute BPM .......beats per minute
sfpm ......... surface feet RPM ....... revolutions per
.................per minute ...............minute
SAVE THESE INSTRUCTIONS FOR
FUTUREUSE
E-SWITCH PROTECTION™
The ON/OFF switch has a no-volt release function. In the event of a
power outage or other unexpected shut down, the switch will need
to be cycled (turned on and off) to restart tool.
E-CLUTCH™
This unit is equipped with an E-Clutch™ (Electronic Clutch), which
in the event of a high-load or wheel pinch, the unit will be shut off
to reduce the reaction torque to the user. The switch needs to be
cycled (turned on and off) to restart tool.
POWER-OFF™ OVERLOAD PROTECTION
The power supply to the motor will be reduced in case of motor
overload. With continued motor overload, the tool will shut off.
The switch needs to be cycled (turned on and off) to restart tool.
The tool will power off each time the current load reaches the
English
7