Filter
Top Products
12 - ENG
HOT WEATHER OPERATION
Tool should operate normally. However, keep tool out of direct sunlight as excessive
heat can deteriorate bumpers, O-rings and other rubber parts resulting in increased
maintenance.
MAINTENANCE
WARNING: Disconnect air line from tool, engage trigger lock and remove
fasteners from magazine before making adjustments or personal injury may
result.
DAILY MAINTENANCE CHART
ACTION WHY HOW
Lubricate tool with
5-7 drops of D
e
WALT
Pneumatic Tool Oil
Prevents failure
of o-rings
Insert drops into air fitting
on end cap of tool
Drain compressor tanks
and hoses daily
Prevents accumulation
of moisture in
compressor and nailer
Open petcocks or other
drain valves on compressor
tanks. Allow any accumulated
water to drain from hoses
Clean canister, feed
piston area and contact
trip mechanism.
Permits smooth
operation of magazine,
reduces wear and
prevents jams.
Blow clean with compressor
air. The use of oils, lubricants
periodically or solvents is
not recommended as they
tend to attract debris.
Before each use, check
to insure all screws,
nuts and fasteners are
tight and undamaged.
Prevents jams, leaks
and premature failure
of tool parts.
Tighten loose screws or other
fasteners using the appropriate
hex wrench or screwdriver.
CLEANING
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
REPAIRS
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
should be performed by a D
e
WALT factory service center, a D
e
WALT authorized service
center or other qualified service personnel. Always use identical replacement parts.
Refer to the Troubleshooting Guide at the end of this section.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
e
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous. To
reduce the risk of injury, only D
e
WALT recommended accessories should be used with this
product.