Filter
Top Products
9 - ENG
NOTE: Be careful not to deform the coil of nails during the loading process. Otherwise,
the nail guide door will not close and the nails might not feed consistently.
9. Close the canister door (I) completely.
10. Close the nail guide door (H) making sure the door latch (e) is completely engaged
as shown in Fig. 6.
ACTUATING TOOL
WARNING: To reduce the risk of injury, ALWAYS wear proper eye ANSI Z87.1 (CAN/
CSA Z94.3) and hearing protection ANSI S12.6 (S3.19) when operating this tool. The
tool can be actuated using one of two modes: single sequential actuation trigger mode
and contact actuation trigger mode.
SingleSequentialactuationtriggermode- (Fig. 7)
WARNING: Allow the tool to recoil off the work
surface after actuation. If the contact trip remains
depressed a nail will be driven each time the trigger is
released and pulled, which could result in accidental
actuation, possibly causing injury.
The sequential actuation trigger’s intended use is
for intermittent fastening where accurate fastener
placement is desired.
TooperatethetoolinSinglesequentialactuation
mode:
1. Depress the contact trip firmly against the work
surface.
2. Pull the trigger.
3. Allow the tool to recoil from the work surface.
Fig. 4
K
L
Fig. 3
J
Fig. 5
M
Fig. 6
E
H
Fig. 7
S
Trigger lock button
Trigger mode selector button