Filter
Top Products
21
A
B
Fig. 68
Fig. 69
OUTBOARD TURNING
For workpieces that require additional space for turning, or for the turning of bowls, etc., outboard turning is the
answer. To make outboard turnings:
1. Remove the tool rest base and the tailstock from the lathe bed.
2. On the headstock, raise the handle (A) Fig. 65 to loosen the tension of the headstock on the lathe bed.
3. Lift the motor slightly and slide the headstock to the end of the lathe bed. (See also Fig. 69)
4. Lower the handle (A) Fig. 65 to lock the headstock in place.
5. Loosen the set screw on the faceplate (A) Fig. 66 two full turns. Use the supplied wrench (B) Fig. 67 to loosen the
face plate, then remove the faceplate from the spindle.
6. Use an outboard tool rest (B) Fig. 68 for all outboard turnings.
7. Fig. 69 illustrates the correct method for outboard turnings.
Fig. 65
Fig. 66
Fig. 67
A
A
B
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).