Filter
Top Products
43
Advanced > Routing > Static Route
IP Address Enter the IP Address of the subnet or device where packets are
to be routed.
Subnet Mask Enter the subnet mask corresponding to the IP address entered
above
.
Gateway Enter the IP address of the gateway used for packets that are
to be routed to the IP address entered above.
Interface Select the WAN (Internet) or LAN interface.
Metric Enter the number of hops (the number of routers) that packets
will be allowed to cross when being routed to the IP address
entered above.
State Use this drop-down menu to Enable or Disable this route.
The Routing table, shown to
the right, allows you to enter
static routes between
computers on both the WAN
(Internet) and your LAN.