Dukane AN200 Welding System User Manual


 
- 2 -
22102
D
U
K
A
N
E
A
A
p
p
p
p
l
l
i
i
c
c
a
a
t
t
i
i
o
o
n
n
N
N
o
o
t
t
e
e
AN200
Rev 01
© Dukane Corporation 2003. All rights reserved.
Dukane Corporation
2900 Dukane Drive Saint Charles, IL 60174 USA
Phone (630) 797-4900 FAX (630) 797-4949
http://www.dukane.com/us
Intelligent Assembly Solutions
2
1
System Input Connector
The System In interface connector is one of the primary communications links between the DPC II / II+ input port and
the user automation equipment. This connector provides the automation with dedicated communication lines that
allow the automation to control the beginning and the end of a welding sequence.
Pin Number DPC Signal Name DPC Signal Type
1 Power Su
pp
l
y
+22 VDC
(
250 mA max
)
2 Ground 22VDC Return
3 Isolated O
p
erate In
p
ut In
p
ut
4 Isolated In
p
ut Common
1
Common for
p
in 3, 5, 9
5 Isolated Press Control
2
In
p
ut
6 Not Used Not Used
7 Ground +22VDC Return
8 Non Isolated O
p
erate In
p
ut
9 Isolated Automation Stop /
Automation End of Weld
3
Input
10 Not Used Not Used
11 Hand Probe Press Inhibit In
p
ut
12 MPC Probe/Setu
p
Bit 0
4
In
p
ut
13 MPC Probe/Setu
p
Bit 1
4
In
p
ut
14 MPC Probe/Setu
p
Bit 2
4
In
p
ut
15 Front Panel Control Lock In
p
ut
Notes:
1. SH707 on the 110-3606 system I/O PCB must be configured to the JU728 position when this
common is used.
2. This input requires the optional 110-3938 press control module. Configuration of the SH901
Jumper on the 110-3938 press control module may also be required.
3. This input is configured for use as Automation End of Weld at the factory. Jumper SH704 must
be reconfigured on the 110-3606 System I/O board to permit use of the Isolated Automation
Stop feature.
4. The MPC probe bit functionality requires the optional MPC feature. The Setup bit functionality
is available on all DPC II+ systems. Please refer to the DPC manual for further details on this
feature.