Filter
Top Products
24
ENGLISH
12. Adjust thrust bearing position (78)
so it just touches the band saw
blade.
13. Tighten screw (79) again.
14. Reinstall the saw table on the upper
table trunnion.
15. Reinstall the fence guide extrusion
for the rip fence.
9.5 Band saw tyre replace-
ment
Periodically check band saw tyres for
wear. Replace only in pairs:
1. Remove band saw blade (see “Care
and maintenance”);
2. Lift band saw tyre with a small
screwdriver, then pull off the band
saw wheel.
3. Mount new band saw tyres and rein-
stall the band saw blade.
9.6 Table insert replacement
The table insert needs replacement
when its slot has become enlarged or
damaged.
1. Remove table insert (80) from saw
table (push up from underneath).
2. Fit new table insert.
9.7 Saw Cleaning
1. Open the lower housing door.
2. Remove the chip case (81) and
empty it.
3. Remove chips and saw dust with
brush or vacuum from:
− inside of the lower band saw
housing;
− blade guides;
− operating elements
4. Swing door catch lever (82) up and
put the chip case back in.
9.8 Saw storage
A
Danger!
Store saw so that
− it can not be started by unauthor-
ized persons and
− nobody can get hurt.
3
Note:
The ON/OFF switch can be safe-
guarded by a padlock.
A
Caution!
Do not store saw unprotected
outdoors or in damp environment.
• Keep surfaces of the saw table
clean – in particular, remove resin
residue with a suitable cleaning and
maintenance spray (optional acces-
sory).
• Afterwards, apply a light coat of slid-
ing compound (e.g. Waxilit).
For special tasks the following accesso-
ries are available at your specialized
dealer – see back cover for illustrations:
A Workstand
for an optimal working height. Pow-
der-coated sheet-metal construc-
tion.
B Band saw blade
induction hardened teeth,
2240 x 12 x 0.5 A6,
for general cutting of wood.
C Band saw blade
induction hardened teeth,
2240 x 6 x 0.5 A6,
for contour cutting of wood.
D Band saw blade
induction hardened teeth,
2240 x 15 x 0.5 A6,
for standard cross cutting of wood.
E Band saw blade
induction hardened teeth,
2240 x 15 x 0.5 A2,
for non-ferrous metals.
F Belt sanding attachment
for finishing cut edges.
G Sanding belt
80 grit, 2240 x 20 (pack of 3 )
H Sanding belt
120 grit, 2240 x 20 (pack of 3 )
I Circle cutting attachment
for sawing circles of 120 to 260 mm
diameter. Optimum cutting results
when used with the contour cutting
blade.
J Mitre fence
for exact mitre cuts.
K Precision roller guide
provides optimum band saw blade
guiding and extended service life.
No tools required to adjust.
L Dust collection adapter for Ø 100
mm port.
M Dust collector
helps to protect your health and to
keep the shop clean.
N WAXILIT sliding compound
improves workpiece sliding on the
saw table.
O Care and maintenance spray
to remove resin residue and pre-
serve metal surfaces.
79
78
80
81
82
10. Tips and tricks
11. Available accessories