Filter
Top Products
10
Setting the PIN for the First Time:
1. Press in order the numbers
2. Press the PROGRAM key
3. Type a new PIN (3-8 digits)
4. Press the PROGRAM key again
The keypad is ready to program to an opener.
For use on a Single Door, continue to Synchronizing
Keypad to Door.
NOTE:
If the keypad lights do not ash and go OFF after
setting PIN, clear the keypad and repeat Step 1; see page
11 for Resetting a PIN.
Locate the Opener’s Programming Buttons and LED:
Synchronizing Keypad to Door
1. Press PROGRAM SET button two seconds until the round LED turns
blue, then release. The long purple LED will blink.
2. Key in the new PIN on the keypad.
3. Press Up/Down key and opener LEDs will stay on steady.
4. Press Up/Down key again and opener LEDs turn o.
5. Press Up/Down key a third time and opener runs.
The process of programming ONE keypad to
ONE opener is complete.
Multiple Door Section:
1. Key in the new PIN on the keypad (3-8 digits).
2. Press the PROGRAM key two times.
3. Enter how many total doors the keypad will control (press 2 or 3
accordingly).
4. Press the PROGRAM key.
The keypad is now programmed to receive multiple opener signals.
5. Locate the opener’s programming buttons and LED.
Press PROGRAM SET button two seconds until the round LED turns
blue; then release. The long purple LED will ash.
6. Type the new PIN (3-8 digits).
7. Press the Up/Down key one time.
8. Assign a number to the door that the keypad will operate by
pressing 1-2 or 3.
9. Press that door number a second time.
10. Press that same door number a third time and the door
will operate.
Wait 30 seconds for the keypad to go dark and then start with step 5 for the
additional door/keypad combination as needed.
To add another opener to a keypad that is already programmed to an
opener, follow all the steps in the“Multiple Door Section”.
Please note at Step 8, that the keypad assumes the
original opener programmed to the keypad is opener #1.
Keypads can accept up to three openers.
Keypad Overview:
Programming Wireless Keypad
(Optional on some models)
PRGM
SET
OPEN BATTERY COVER AND PULL PAPER TAB
TO ALLOW OPERATION
Tip: Program Keypad before mounting.