Filter
Top Products
3
Features
Begin here ONLY AFTER completing assembly and installation of the opener. Review the Assembly and Installation Poster to ensure all
steps have been performed.
V
isit www.GenieCompany.com to download a printable le.
SAFETY FEATURES
Safe-T-Beam® (STB) Non-Contact
Reversing System
Puts an invisible beam across the door open-
ing. The door stops and reverses to the full
open position if anything passes through
the beam. LED indicator lights on the power-
head and on the STBs provide self-diagnos-
tics if an operational problems exists.
Safe-T-Reverse® Contact Reversing System
Automatically stops and reverses a closing
door within two seconds of contact with an
object.
Automatic ForceGuard™ Control
Automatically sets the force required to
fully open and close the door for maximum
safety.
Door Detect™ Monitoring System
Monitors the Safe-T-Beam® system to ensure
proper functionality and will automatically
stop and reverse a closing door if a problem
is detected.
Manual Emergency Release
Manually releases door from door opener.
Used during a power failure or other emer-
gency to allow manual opening and closing
of door.
SmartSet
®
Electronic Programming
Easily adjust the programming to set limits
and program new remotes.
Automatic Lighting System
Single or Dual Bulb lighting system supplies
light for safer evening exits and entries. Turn
ON when door is activated and automatical-
ly turns OFF 4 minutes later.
Integrated Motion Detection (Optional on some
models)
Lights automatically turn ON when mo-
tion is detected for much safer movement
through the garage. Lights will turn OFF
after four minutes of no motion.
Safe-T-Beam® (STB) FUNCTION
1. The Safe-T-Beam® has no eect on the door during an opening cycle.
2. If the Safe-T-Beam® detects an obstruction when trying to close the
door, it will not allow the door to close.
3. When the garage door is closing, if Safe-T- Beam® is interrupted by
a person or obstacle, the garage door will stop its downward travel
and reverse automatically to its fully opened position.
4. If the Safe-T-Beam® System fails, loses power, or is installed
improperly, press and hold the wall console “open/close” button
until the door reaches its fully closed position. If you release
the “open/close” button on the wall console during the closing
movement, the door will reverse automatically to its fully-opened
position.
OPENER FEATURES
Intellicode®
An encryption system that enhances the security
of the door opener by continuously changing
the access code each time the remote is used.
The door opener responds to each new code
only once. An access code copied from a
working system and tried again, will not control
the door opener.
Wall Console
Operates door opener from inside garage.
The wall console has an indicator light with:
Open/Close, Sure-lock™, and independent
light control buttons.
Home Link® and Car2U® compatible. See page 12
in this manual, refer to the motor vehicle manual or
visit www.GenieCompany.com for instructions.
Pre-Programmed Remote Control
For ease and speed of installation, the remote
included with this opener comes from the factory,
pre-programmed. No additional steps are required
to activate the door using the remote.
NOTE: Use this manual ONLY after completing assembly and
installation of the opener.
Review the Assembly and Installation Instructions poster. Check
that all steps have been completed.