Genie 3062m3064 Welder User Manual


 
11
Programming Wireless Keypad
(Continued)
Door Operation with Wireless Keypad:
To open and close a single door with the Keyless Entry Pad, enter
the PIN number and press Up/Down Key (enter).
For multiple doors enter the PIN number, press the UP/Down Key once
and enter the door number (1,2 or 3).
Mounting Keypad
The keypad MUST be mounted within sight of the garage door(s) at
least ve feet above the oor and clear of any moving door part.
1. Remove battery cover and batteries.
2. Drill 3/32” pilot hole for the top mounting screw (included).
3. Install a screw into the pilot hole, leaving a 1/8” gap between the
screw head and wall.
4. Hook the slotted mount, on back of keypad, over the screw.
5. Mark and drill a pilot hole for the bottom screw (included) and
secure keypad to wall (DO NOT overtighten).
6. Reinstall batteries and cover.
NOTE: The Keyless Entry Pad will stay active for 30 seconds and
will stop or start the door with each touch of any button on the
keypad.
Changing an Existing PIN:
1. Enter the current PIN
2. Press the Program key one time
3. Key in the new PIN (3-8 digits)
4. Press the Program key one time
NOTE:
Unlike “Resetting PIN,” there is no need to reprogram your
opener after changing the PIN.
Resetting a PIN:
Press and hold both the PROGRAM key and the Up/Down key
for about ve seconds.
The LED’s will slowly blink and then go out. When the LED stops
blinking, the old programming has been successfully erased.
To create a new PIN, start with “Setting the PIN for the First Time”