Filter
Top Products
6
Programming Information
TRAVEL LIMITS
NOTE: If carriage has NOT been engaged to carriage, do so now.
Before setting limits:
conrm wall console red indicator
back light is ON. If not illuminated, See page 19 for troubleshooting.
Check STB LED’s: Conrm both LED’s are Illuminated solid. If not
Illuminated solid, see page 18 for troubleshooting.
Closing Garage Door (Down Limit)
NOTE:
Beginning with garage door in mid travel is recommended but not
necessary.
WARNING
!
• Make sure doorway is in full view and clear of obstacles and
people to avoid injury or property damage.
• DO NOT operate this unit from the wall control before LIMITS
are set. Severe damage to the opener could occur.
• The carriage MUST be engaged BEFORE setting limits. See
installation poster (if provided) or call Customer Service at
1-800-35-GENIE or visit www.GenieCompany.com.
AVERTISSEMENT
!
• S’assurer que le passage de la porte est visible et dégagé, à
savoir sans obstacles ni personne an d’éviter toute blessure
potentielle ou dommage matériel.
• NE PAS utiliser cette unité avec la console murale avant
d’avoir réglé les LIMITES. L’ouvre-porte pourrait subir de
sérieux dommages.
• La tendeur DOIT être engagée dans le chariot AVANT de
régler les limites. Voir le poster d’installation (si fourni) ou
appelez le service clientèle au 1-800-35-GENIE ou visitez le
site www.GenieCompany.com.
• NE PAS xer de limites en mode batterie de secours.
L’alimentation CA DOIT être branchée sur l’ouvre-porte,
pendant le réglage des limites, pour assurer un bon
fonctionnement.
PRGM
SET
PRGM
SET
PRGM
SET
PRGM
SET
READ AND UNDERSTAND STEPS 2-5 BEFORE
PROCEEDING
2. Press and hold the down arrow button (–) for two
seconds or until the long LED comes on blue. (The round
LED stays o.)
Steady Blue
3. Release down arrow button (–) and the long LED will
begin ashing blue. (Round LED still o.)
Flashing Blue
5.Pressandreleasetheprogram/setbutton—bothLEDs
ash blue and then go o.
The DOWN (CLOSED) TRAVEL LIMIT IS NOW PROGRAMMED.
Flashing
Blue
4. Press and hold the down arrow button (–) to begin
closing the garage door. When the garage door is fully
closed, release the down button (–). If it has gone too far
press and release the up button (+) to move the door
up slightly. The door can be moved up or down with the
arrow buttons. The door should rest tightly on the oor.
1. Lift door by hand until carriage engages the shuttle on
screwdrive or the bullet on the chain/belt.
Lever must be UP
Lever must be UP
Screw
Drive
Chain/
Belt Drive