Graco 238511 Stud Sensor User Manual


 
2 309377
Table of Contents
W arnings 2......................................
Installation 4.....................................
Setup 7.........................................
Operation 11....................................
T roubleshooting 13...............................
Service 16......................................
Parts List 18.....................................
Parts Drawing 19.................................
Technical Data 20................................
Dimensional Drawing 21..........................
Graco Standard Warranty 22......................
Graco Information 22.............................
Symbols
Warning Symbol
WARNING
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the possibility of damage to
or destruction of equipment if y ou do not follow the
instructions.
EQUIPMENT MISUSE HAZARD
Equipment misu se c an cause the equipment to r upture or malfunction and result in serious injury.
D This equipment is for p rofessional use only.
D Read all instruction manuals, tags, and labels before you operate this equipment.
D Use the equipm ent only for its i ntended purpose. If you are not sure, call y our Graco d istributor
for assistance.
D Do not alter or modify this equipment. Use only genuine Graco par ts and accessories.
D Do not leave this dispense valve unattended while it is dispensing.
D Check equipm ent daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated system component. See the
Technical Data on page 20 for the maximum working pressure of this component.
D Use fluids and solvents that are compatible with the equipment wetted parts. See the Technical
Data section of all equipment manuals. Read the fluid and solvent manufacturer’s w arnings.
D Route hos es away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180_ F(82_ C) or below --40_ F(--40_ C).
D Comply with all applicable local, state, and national fire, electrical, and safety regulations.
D Do not point the dispense valve at any one or at any part of the body.
D Do not put your hand or fingers o ver the end of the dispense valve.
D Do not stop or deflect leaks with your hand, body, g love, or r ag.
D Use only extensions and nozzles that are designed for use with this dispense valve.
D Follow the Pressure Relief Procedure on page 5 before you clean, check, or service this
equipment.
D Ti ghten all fluid connections before you oper ate this equipment.
D Check the hoses, tubes, and couplings daily. Replace worn or dam aged parts immediately. Do
not repair high pressure couplings; you must replace the entire hos e.
WARNINGWARNING
INSTRUCTIONS