Graco 249007 Paint Sprayer User Manual


 
Clutch Housing
311019L 11
Clutch Housing
Removal
1. Remove clamp. Do Clamp Removal, page 10.
2. FIG. 11. Remove four screws (51) and lock washers (50)
which hold clutch housing (45) to engine.
3. Remove screw (145) from under mounting plate.
4. Pull off clutch housing (45).
Installation
1. FIG. 11. Push on clutch housing (45).
2. Install four capscrews (51) and lock washers (56) and
secure clutch housing (45) to engine. Torque to 200 in-lb
(22.6 N·m).
3. Install screw (145) from beneath mounting plate. Torque
to 26 ft-lb (35.2 N·m).
FIG. 11
Engine
Removal
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
1. Remove Pinion Assembly/Clutch Armature/Clamp and
Clutch Housing, as instructed on pages 9, 10 and 11.
2. F
IG. 12. Disconnect all necessary wiring.
3. FIG. 13. Remove two locknuts (111) and screws (110)
from base of engine.
4. Lift engine carefully and place on work bench.
FIG. 12
F
IG. 13
Installation
1. Lift engine carefully and place on cart.
2. FIG. 13. Install two screws (110) in base of engine and
secure with locknuts (111). Torque to 20 ft-lb (27.12 N·m).
3. F
IG. 12. Connect all necessary wiring.
4. Install Pinion Assembly/Clutch Armature/Clamp and
Clutch Housing, as instructed on pages 9 and 10 and 11.
5. Set engine to 3300 rpm.
ti6322a
145
51
50
45
ti6390a
pink
(from engine)
green/yellow
ground
clutch wires
ti6323a
110
111