Graco 249007 Paint Sprayer User Manual


 
Troubleshooting
311019L 7
Problem Cause Solution
Pump output is low Strainer (56) is clogged Clean strainer.
Piston ball (206) is not seating Service piston ball. Manual 309250.
Piston packings are worn or damaged
Replace packings. Manual 309250.
O-ring (227) in pump is worn or damaged
Replace o-ring. Manual 309250.
Intake valve ball is not seating properly
Clean intake valve. Manual 309250.
Intake valve ball is packed with material
Clean intake valve. Manual 309250.
Engine speed is too low
Increase throttle setting. Manual 311016.
Clutch is worn or damaged Adjust or replace clutch. Page 9.
Pressure setting is too low Increase pressure. Manual 311016.
Fluid filter (104), tip filter or tip is
clogged or dirty
Clean filter. Manual 311016 or 309741.
Large pressure drop in hose with
heavy materials
Use larger diameter hose and/or
reduce overall length of hose. Use of
more than 100 ft of 1/4 in. hose signifi-
cantly reduces performance of sprayer.
Use 3/8 in. hose for optimum perfor-
mance (50 ft minimum).
Excessive paint leakage into throat
packing nut
Throat packing nut is loose Remove throat packing nut spacer.
Tighten throat packing nut just enough
to stop leakage.
Throat packings are worn or damaged
Replace packings. Manual 309250.
Displacement rod is worn or damaged
Replace rod. Manual 309250.
Fluid is spitting from gun Air in pump or hose
Check and tighten all fluid connections.
Reprime pump. Manual 311016.
Tip is partially clogged Clear tip. Manual 309639.
Fluid supply is low or empty Refill fluid supply. Prime pump. Manual
311016. Check fluid supply often to
prevent running pump dry.
Pump is difficult to prime Air in pump or hose
Check and tighten all fluid connections.
Reduce engine speed and cycle pump
as slowly as possible during priming.
Intake valve is leaking Clean intake valve. Be sure ball seat is
not nicked or worn and that ball seats
well. Reassemble valve.
Pump packings are worn
Replace pump packings. Manual 309250.
Paint is too thick Thin the paint according to the sup-
plier's recommendations
Engine speed is too high Decrease throttle setting before prim-
ing pump. Manual 311016.
Clutch squeaks each time clutch
engages
Clutch surfaces are not matched to each
other when new and may cause noise
Clutch surfaces need to wear into each
other. Noise will dissipate after a day of
run time.
High engine speed at no load Misadjusted throttle setting Reset throttle to 3300 engine rpm at no
load
Worn engine governor Replace or service engine governor