Filter
Top Products
Setup
3A1456D 11
Install Tip/Guard Assembly
(if not installed)
Reversible Tip Selection Chart
1. Engage trigger lock and put prime/relief valve UP to
release pressure. Then remove Tip/Guard Assembly.
2. Install filter to Spray Tip/Guard Assembly (make sure
filter is fully installed into sprayer). NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
3. Screw Tip/Guard Assembly onto sprayer. Tighten
retaining nut until completely engaged with sprayer.
Shoulder Strap Installation
1. Attach the metal eyelet to the back of the sprayer.
2. Open the velcro end of the strap, then route it
through the slot under the tip of the sprayer.
3. Route velcro up through the metal triangle, then fold
down and attach velcro to strap.
MATERIALS
*Thin Medium Heavy
Thin stains,
semi-transparent stains
Enamels, solid
stains, thin latex
Heavy latex
211, 411 213, 413 315, 515, 517
*Install Fine-Finish Optimizer, see page 9.
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid damage to the filter.
NOTICE
The tip is a permanently attached to the Tip/Guard
Assembly. Removal will result in damage.
ti14999a
ti14994a
ti14775a