Filter
Top Products
Maintenance
332574D 11
Replace Anvil
For part references, see FIG. 5 on this page and cutter
parts illustration on page 20.
1. Follow Pressure Relief Procedure found within the
RS Gun and Cutter, Operation-Repair manual.
2. Engage trigger lock.
3. Loosen knob (628) then remove cover (627). See
page 20.
4. Use hand to prevent anvil from spinning, then push
in and rotate anvil cap (AD) 90 degrees coun-
ter-clockwise to remove.
5. Loosen the anvil to blade tension lockdown
lever (AG).
6. Use the anvil to blade tension adjustment knob (AF)
to relieve the tension between the anvil and blades.
7. Remove anvil (AC).
8. Install new anvil onto sleeve.
9. Install anvil cap.
10. Install cover and knob.
11. Adjust Anvil to Cutter Head Tension, page 8.
FIG. 5
Blades are sharp. Always wear protective gloves to
prevent cuts when the cutter cover is removed.
AK
AH
AG
AF
AE
AJ
AB
AA
AD
AC
AP
AN
NOTICE
More tension between the anvil and blades leads to
the anvil and blades wearing out faster. To prevent
premature wear and to maximize anvil and blade
life, use the minimum tension required to cut the
glass and make small increases in tension when
strands are not cut correctly.