Filter
Top Products
Setup
6 332574D
Setup
1. Engage trigger lock.
2. Install cutter:
a. If necessary, use a crescent wrench to adjust
pivot (541) so that it is parallel to gun front end
and the open end points to the front of the gun.
See F
IG. 3.
b. Back out screws (630). See F
IG. 3.
c. Install cutter onto pivot so glass feed holes are
on top.
NOTE: Ensure proper engagement of o-ring (542) into
the cutter assembly. Verify there is no excess air leak-
age because it will greatly reduce the performance of
the air motor. See F
IG. 3.
d. Tighten screws (630) to lock cutter in place.
e. Adjust cutter dispensing angle and chute angle
as desired.
3. Insert glass strands into feed.
4. Adjust anvil to blade tension:
a. Release lockdown (AG). See F
IG. 1 on page 4.
b. Adjust tension knob (AF) as desired.
c. Tighten lockdown (AG).
d. Release idler lock down screw (AN).
e. Adjust idler wheel (AJ) until it touches anvil
(AC).
f. Tighten idler lock down screw (AN).
g. Perform test spray to verify proper cutting of
glass strands.
h. Adjust tension as necessary.
F
IG. 3
541
542
630
ti21008a