Filter
Top Products
30941412
Trigger Sensor Adjustment
Refer to Troubleshooting for tri gger sensor adjust-
ment, and Manual 309413.
Distance Sensor Adjustment
Gear Alignment
1.
Relieve press ure; page 4.
2. Fig. 7. Remove dust cap (74) from wheel.
Remove nut (62).
3. Remove wheel (82) from LineLazer.
4. Align gear (57) with sensor.
a. Pull gear out from wheel with gear puller.
b. Push gear in toward wheel with mallet.
5. Install wheel (82) on LineLazer.
6. Install nut (62) until ti ght, then back off 1/4 turn.
Install dust cap (74) on wheel.
Sensor Height Adjustment
1. Remove wheel (82) from LineLazer.
2. Remove sens or assembly (58).
3. Adjust sensor assembly height with two 17 mm
nuts of sensor so bottom surfa ce of sensor is
0.638 +/--0.020 from bottom surface of shield.
Torque to 8 +/-- 2 in-lb.
Fig. 7
ti1955a
Inside of tire
.638 in.
Tire
Distance
Sensor
Gear
Frame
Axle