Filter
Top Products
15308846
Accessory Suction Tube Kit
Suction Tube Kit 240465
Ref.
No. Part No. Description Qty.
201 232692 KIT ASSEMBLY, suction tube 1
202 193411 NIPPLE 1
203 193459 TUBE, recirculation 1
204 103473 TIE, wire 5
The Suction Kit, listed above, can be installed for
drawing fluid from a container that is not directly under
the unit. Install the Suction Kit as follows (see Fig. 4):
1. Remove the following parts from the stand unit:
recirculation tube (28), suction tube (3), male
connector (44), and suction line strainer (43). See
the Parts Drawing on page 13.
2. Apply thread sealant (specified in Fig. 4) to the
threads of the nipple (202).
3. Thread the nipple (202) into the pump inlet.
4. Thread the fitting of the suction tube assembly
(201) onto the nipple (202).
5. Install the new, longer recirculation tube (203) in
place of the old one.
6. Bundle the new suction tube (201) and
recirculation tube (203) with the wire ties (204).
7. Route the new tubes into the remote fluid
container.
Fig. 4
} Apply Graco Thread Sealer, or LoctiteR 567, or equiv-
alent to threads.
8172A
201
202}
203 204