Filter
Top Products
Shutdown and Cleaning
16 309225W
Triggering Gun
Pull trigger after starting stroke. Release trig-
ger before end of stroke. Gun must be moving
when trigger is pulled and released.
Aiming Gun
Aim tip of gun at bottom edge of previous
stroke, overlapping each stroke by half.
Shutdown and Cleaning
Pail Flushing
1. Turn power switch OFF. Lift
suction tube and prime tube
from paint pail. Let them
drain into paint for a while.
2. Place suction tube in pail filled with flushing
fluid and place prime tube in waste pail.
3. Turn Spray-Prime/Drain
Valve to PRIME.
4. Turn Pressure Control
knob to the left
(counter-clockwise) to
minimum pressure.
5. Trigger gun into waste
pail to relieve pressure in hose.
6. Remove tip and guard assembly from gun
and place in flushing fluid.
TIA
TIA
If spraying lacquers, purchase Lacquer Conversion Kit 248202. Follow Shutdown and
Cleaning procedures for oil-based materials.
• For short term shutdown periods (up to
2 days) refer to Short Term Storage,
page 20.
• For flushing after spraying oil-based
coatings, use compatible oil-based
flushing fluid or mineral spirits. Read
Priming, Oil- or Water-based Materi-
als, page 10.
• For flushing after spraying water-based
coatings, use water. Read Priming, Oil-
or Water-based Materials, page 10 or
Power Flush, page 17.
WLD
02)-%
WLD
TIA
&,53().'
&,5)$