Filter
Top Products
Shutdown and Cleaning
309225W 17
7. Turn power switch ON.
8. Slowly align arrow on
sprayer with Pail
symbol on Pressure
Control knob until
pump starts.
9. Flush until approximately 1/3 of the flushing
fluid is emptied from the pail.
10.Turn power switch OFF.
Turn Spray-Prime/Drain
valve to SPRAY.
11.To preserve paint in hose, trigger gun into
paint pail to expel the remaining paint.
12.Turn power switch ON. Continue to trigger
gun until you see flushing fluid starting to
come out of gun nozzle. Release trigger.
13.Move gun to waste pail and trigger it to
flush pump, hose and gun into waste pail.
Continue until remaining flushing fluid is
gone from flushing fluid pail.
14.Fill unit with Pump Armor
™
storage fluid. Read Long Term
Storage, page 20.
Power Flush
Power flushing is a faster method of flushing. It
can only be used after spraying water-based
coatings.
1. Turn power switch OFF. Lift
suction tube and prime tube
from paint pail. Let them
drain into paint for a while.
2. Place suction and prime tube in waste pail.
3. Turn Spray-Prime/Drain Valve
to PRIME.
4. Turn Pressure Control knob
to the left (counter-clock-
wise) to minimum pressure.
5. Trigger gun into waste pail to relieve pres-
sure in hose.
6. Remove tip and guard assembly from gun
and place in flushing fluid.
7. Screw power flush attach-
ment to garden hose. Open
valve.
8. Turn on water. Rinse paint
off suction tube, prime tube
and inlet screen.
WLD
TIA
302!9
TIA
0UMP!RMOR
TIA
WLD
02)-%
WLD
TIA
&,53().'
&,5)$
TIA
OPEN